Ceramic anti-static raised floor is a kind of raised floor which takes anti-static ceramic tile as the surface layer and is pasted on the base material of all steel floor or composite core. It is widely used in various machine rooms through supporting corresponding support stringers. It has the characteristics of high wear resistance, fire prevention, waterproof, high bearing capacity, long service life, easy cleaning and beautiful appearance.

The ceramic anti-static raised floor is applied to various high-end computer rooms, mainly including: intelligent high-end office buildings, Level 5 intelligent buildings, which fully meet the high frequency and easy to clean use. The computer rooms of banks, posts and telecommunications, petroleum, high-end, program control computer rooms, power departments, microelectronics production and installation workshops, and pipeline laying are relatively concentrated, which have the requirements of dust prevention and anti-static, and can also be used for air supply in computer rooms and underground downlink lines.

Senmai anti-static flooring manufacturers have been focusing on anti-static flooring for many years. Their products include all steel anti-static flooring, ceramic anti-static flooring, PVC anti-static flooring, calcium sulfate anti-static flooring, calcium sulfate network flooring, GRC network flooring, calcium sulfate anti-static flooring, OA network flooring, and a one-stop service of design, production and installation.

When installing the anti-static raised floor with ceramic surface, pay attention to the following matters:
1.For products with professional assembly technology, professional technical construction teams must be invited to assemble, and both efficiency and accuracy must be clearly believed.
2.Check the tightness of the floor heating system before paving.
3.The floor must be dry. The moisture content of the cement floor should be less than 1.5% as far as possible. The indoor humidity should not be too high. Whether there is geothermal heating or not, the relative humidity of the air before and after assembly should be about 60 degrees.
4.It is strictly prohibited to drive nails on the ground during construction to prevent damage to the heating system.
5.Before the anti-static floor is paved, the composite film shall be paved to block the moisture, so that the moisture can be released from around the skirting board.